Actron Ac Error Codes
Conditions: The system
does not start.
Remedy:
- Check
that 5 minutes has passed from the time you turned the system on as there
are in-built safety timers.
- When
This Occur Check thermostat settings are correct.
- After
This Happens Check thermostat set point is low enough for cooling or high
enough for heating.
- Check the Master Controller And set to the
correct mode for COOL/AUTO/HEAT.
Conditions: Air does
not flow.
Remedy:
- Check
if the unit is set in the correct mode COOL/AUTO/HEAT.
- Check
zone control in running mode.If using sensor ensure your zone is on at the
master.
- During defrost cycle of the outdoor unit in
heating mode, the indoor fan will not operate.
Conditions: OFF is
displayed on my zone control and I can not turn it on.
Remedy:
Master Controller is
off. First turn on your air conditioner at the master control. You will now be
able to turn on your zone control.
Setting Upper Limit
- Press
the right hand side of the controllers ‘up’ arrow button once followed by
the left hand side of the controllers ‘up’ arrow button once.
- You
must press the two buttons in ‘Quick Succession’.
- The
display will now show the “upper” limit for 3 seconds and this is
indicated by “high” also being illuminated.
- Whilst
the “upper” limit is displayed, use the set-temp arrow button to adjust
the ‘upper’ limit up or down.
- After 5 seconds, the ‘upper’ limit will be
automatically accepted.
Note:
- You
cannot adjust the ‘upper’ limit below your current set-temp.
- You cannot adjust the ‘lower’ limit above your
current set-temp.It is not recommended to adjust the ‘upper’ and ‘lower’
limits outside the defaults, before talking with your installer. Doing so
may cause damage to your system and void warranty. Default ‘upper’ and
‘lower’ limits = upper (30°c) and Lower (16°c).
14. My unit
continuously shuts down whilst in heating mode
At certain outdoor
conditions (low temperature) there may be a build up frost on the outdoor heat
exchanger. This gradual build up frost reduces the performance of the air
conditioner. The microprocessor detects this frost build up and will
automatically activate the defrost mode. This is a normal function of a reverse
cycle air conditioning system, and can occur every 20 minutes. There is water
running from my outdoor unit whilst in heating mode
When the unit is on the
heating cycle, the outdoor coil will condensate, so water may be found
underneath the outdoor unit after use. As the ambient temperature decreases,
the unit will need to defrost more frequently, and cause more water to melt off
the coil. This is normal operation and only happens during the winter months.
- single-digit
number (eg 9)
- the
heat and cool indicators flashing simultaneously
- both codes showing together
Take note of the fault code and contact your installer.
This Actron Ac Error codes will indicate to the installer/repairer what the
problem may be.
Error Codes
|
Problem
|
E1
|
Outdoor coil sensor open or closed circuit
|
E2
|
Fault indoor coil out sensor
|
E3
|
Fault room sensor
|
E4
|
Fault indoor coil sensor
|
E5
|
Communication error between outdoor and indoor
|
E6
|
Fault Discharge temperature
|
E7
|
Fault outdoor coil sensor
|
E8
|
Fault outdoor discharge sensor
|
E9
|
High or Low Pressure/Phase error
|
