Aerotek Air Conditioner Error Codes
Aerotech produces climate equipment that does
not The modern world is inferior to analogs and has fairly reasonable
prices.All products are distinguished by the optimal “price-quality” ratio.
forAir conditioners of this brand are used to produce components High
quality only. Therefore, for all the company’s equipment The warranty is 3
years. Aerotech’s air-conditioner has a high degree of reliability.
E0 – There was an error in determining the
water flow rate;
E1 – An error Happened while adding steps;
E2 – A communication error has Happened;
E3 – There was a fault in the temperature
sensor of the cooling liquid at the outlet;
E4 – Water temperature sensor error
Happened while exiting
Shell-and-tube heat exchanger;
E5 – An error Happened in the temperature
sensor of the capacitor A’s tubes;
E6 – There was an error in the temperature
sensor of the tubes of capacitor B;
E7 – An error Happened in the outdoor
temperature sensor;
E8 – An error Happened in the tem. sensor
in the discharge line Compressor system A;
E9 – An error Happened while determining
the flow of water;
EA – The main unit reported a decrease in
the number of additional blocks;
EB An error Happened in the temperature
sensor of the-protection system
Freezing of heat exchanger;
European Union – One of the modular units
has no output;
ED There was a communication error between
the-modular unit and the drive controller;
Aid – protection of power supply;
EE – There was a communication error
between the computer and the drive controller;
EF – An error Happened in the temperature
sensor at the inlet water;
P0 – The injection line of System A had an
overheating;
Р1 – System A had a decrease in pressure;
P2 – There was an over temperature in the
injection line of System B;
P3 -The B system had a decrease in
pressure;
P4 – Overcracked in System A;
P5 – Overcracked in System B;
P6 – The pressure in the condenser of
system A was increased;
P7 – The pressure in the capacitor of
system B is increased;
P8 – Temperature sensor errors in discharge
line Happened
Compressor system A;
P9 – protection against water temperature
differences at the outlet and inlet;
RA – protection against supercooling during
start-up;
KBB – There was a frost;
PE -The shell-and-tube heat exchanger
was supercooled;
F1 – Errors in permanent memory;
F2 – Errors Happened while connecting wired
controllers
