Logik AC

Logik Air Conditioner Error Codes

LED Display Description

---

E1 internal malfunction. Turn off the unit. Unplug and re-plug the unit. If the error persists, call a qualified service agent for assistance.

---

E2 internal malfunction. Turn off the unit. Unplug and re-plug the unit. If the error persists, call a qualified service agent for assistance.

---

E4 internal malfunction. Turn off the unit. Unplug and re-plug the unit. If the error persists, call a qualified service agent for assistance.

---

P1 drain the water. Please refer to the section “Stopping Water”.

---

Logik Air Conditioner Error Codes

Logik portable air conditioner troubleshooting

Logik portable air conditioner troubleshooting

Problem: No power is started when the unit is started or pressing ON / OFF on the remote control.

Solution:

Check that the unit is firmly plugged in and the main socket is on.
Set a different temperature.
Remove water from the bottom tray drain outlet.
Problem: the room is not cold enough

Solution:

Check that all windows and doors are closed.
Remove or switch off all heat sources if possible.
Check that the exhaust air duct is properly connected and not blocked. If blocked, clear and reconnect.
Clean and securely fit the air filter before continuous operation.
Lower the temperature.
Problem: Noise or excessive vibration

Solution: Move the unit to a stable, flat and flat surface

Problem: Gurling is heard.

Solution: This is normal; It should not be considered a defect.

If there is a problem, contact a qualified service agent for assistance.

Logik portable air conditioner remote control
Logik portable air conditioner remote control

Draw water

When the LED display shows “P1″, it means that the bottom tray is filled with water and needs to be filled with water. The unit will shut down automatically and cannot be turned on until water drainage occurs.

Move the unit to a drain location.
Remove the bottom tray drain outlet cover and plug.
After the water has completely dried, replace the plug and cover.
Switch on the unit until “P1” disappears.
If “P1” continues to perform, unplug the unit and call a qualified service agent for assistance.

 How do I reset my portable air conditioner?

Find the Reset Button – Many air conditioning units will have a reset button on them. The button is usually red in color and fairly small in size. It should be marked clearly as a reset button. You can consult the instructions manual to determine if your air conditioning unit has that button, and find its location.

How do you troubleshoot a portable air conditioner?

Similar to the last problem mentioned, to diagnose the problem of the portable AC not cooling enough, first check the filter and see if it is clogged or dirty. If it is, clean it. Then, look for any air intake obstructions and remove them. Inspect the exhaust hose and see if there is any obstruction here.

What does E4 mean on my portable air conditioner?

E4 means it’s in defrost mode, just check your filters to be sure they’re clean also, once it defrosts the error code should disappear. KeegsMom.

What does E2 mean on a portable air conditioner?

Low Pressure

“E2” – Low Pressure: The pressure of the compressor is too low. The ‘Error’ LED will be on. Solution: Clean filters & coils. Verify Power. Check filters evaporator/condenser.

Why is my portable AC not blowing cold air?

If your Portable Air Conditioner is not blowing cold air please check the following: check that the unit temperature setting is lower than the room temperature; check that the fan is blowing warm air from the back of the unit; check that you hear the compressor kick on after start up (could be a 3 minutes delay);

What Should You Do When Your Portable Air Conditioner Displays An E4 Error Code?

1. Change your air filters.
2. Have a professional an EPA licensed AC technician check your refrigerant levels.
3. Clean evaporator and condenser coils annually.
4. Make sure you have an adequate power supply.