Carrier Cassette
Error Codes
Carrier
Cassette Ac Error Codes and Troubleshooting
Once a failure occurs
with the indoor unit in operation, the green unit LED flashes at intervals of
0.5 seconds. The fault code is deduced from the number of times the green LED
flashes, blocking unit operation. Between one flash cycle and the next one, a
pause of 5 seconds elapses.
Error Codes
|
Description
|
3
|
Room air sensor fault
|
2
|
Condensate discharge pump
|
4
|
Indoor unit coil sensor fault
|
6
|
Filter dirty
|
7
|
Outdoor unit failure
|
10
|
EEPROM corrupt
|
11
|
Card serial number damaged
|
12
|
Address / zone incomplete
|
13
|
Gas flow distributor corrupt
|
14
|
Outdoor air thermistor
|
Air conditioner
will not start:
- Check
The Main Switch Is Off. Turn On The Main Switch.
- The
fuses In the main switch are Spark; replace the fuses. ( this Work Is A
Trained Technician).
- Wait
for 3 minutes: protection against frequent compressor cycling is ON.
- The selected temperature is higher than the
room temperature (or lower in the heating mode).
The unit emits unpleasant smells:
Unpleasant smells can
accumulate on the air filters and then be dispersed into the room during when
air conditioner is in operation mode. Switch the unit OFF and contact an
authorized service center to have the filters cleaned. Restart unit in the
ventilation (fan only) mode and open windows to change room air.
The unit makes
strange noises:
Occasionally the unit
makes strange noises at start-up, during operation or when it has stopped.
These are generally due to the effect of temperature changes on the plastic
parts.
Air conditioner
is not supplying enough cooling (or heating):
- Air
cannot circulate freely.
- A dirty
filter reduces air quantity circulating.
- Clean
The Filters Of Indoor Unit Is Must.
- Doors
and/or windows are open.
- Set The
Fan Speed On Low Mode.
- Airflow
direction is not correct for optimum ventilation.
- The selected temperature is not correct.
P (Green LED)
indicator is flashing:
System malfunction.
Contact service organization after having ensured that:
- There
Is No Obstructed In Air Circulation.
- Outdoor
unit coil is not Faulty and causing low speed of air circulation.
- Condensate drainage tube is not obstructed.
Q (Red LED)
indicator is illuminated:
In the heating mode,
the LED switches on to indicate an active defrost condition.