Acson Wall Mount
Split
Fault: The compressor does not operate 3 minutes after the air conditioner unit is started.
Causes / Action: -Protection against frequent starting. Wait for 3 to 4 minutes for the compressor to start operating.
Fault: The air conditioner unit does not operate.
Causes / Action:
– Power failure, or the fuse needs to be replaced.
– The power plug is disconnected.
– It is possible that your delay timer has been set incorrectly.
– If the fault persist after all these verifications, please contact the air conditioner unit installer.
Fault:The air flow is too low
Causes / Action:
The air filter is dirty.
– The doors or windows are open.
– The air suction and discharge are clogged.
– The regulated temperature is not high enough
Fault:Discharge air flow has bad odour.
Causes / Action:
– Odours may be caused by cigarettes, smoke particles, perfume etc. which might have adhered onto the coil.
Fault: Condensation on the front air grille of the indoor unit.
Causes / Action:
– This is caused by air humidity after an extended long period of operation.
– The set temperature is too low, increase the temperature setting and operate the unit at high fan speed.
Fault: Water flowing out from the air conditioner unit.
Causes / Action: – Switch off unit and call dealer
Fault:Hissing air flow sound from the air conditioner unit during operation.
Causes / Action: – Refrigerant fluid flowing into the evaporator coil
If the fault persists, please call your local dealer / serviceman
